stump grinderThe motor and mechanical parts of the machine are conveyor belts, which may slip when used for a long time. Stop the equipment first and adjust the tightness of the conveyor belt.
If loosening occurs several times, the position of the motor should be adjusted. Then slow down the stump grinder, loosen the fixing nut of the motor, and move the motor to a reasonable position; when the conveyor belt cannot be too tight, it will affect the performance of the conveyor belt. Service life. After the conveyor belt is damaged during use, it must be replaced with a new 3-angle or V-shaped conveyor belt. When replacing the belt, the length and pulling force must be consistent to avoid premature damage due to uneven force. 3-angle belt of tree stump crusher If the adjustment is too tight, it will also reduce the speed of the motor, causing the motor bearings to heat up; and if it is too tight, the conveyor belt will easily slide, which will seriously affect the life of the motor and belt.
Therefore, the tightness of the tree stump grinder belt can also be adjusted according to the bolts of the machine base. Use the adjusting bolts to change the position of the motor on the slide, so that the 3-angle belt reaches the required tightness, and then tighten the fixing bolts. Belt The tightness of the conveyor belt should be installed in such a way that it can be pressed by hand to allow the conveyor belt to float up and down. During the process, the best part of the conveyor belt can be adjusted.
