If usedWood crusherWhen recycling waste wood, a lot of dust often flies out, which directly causes the problem of smoke and dust pollution at the production site. This not only affects the physical and mental health of the workers, but also affects the working environment of the wood crusher. , therefore often cause pollution to the surrounding environment due to insufficient implementation of smoke and dust treatment. In the long run, it not only brings certain safety hazards to the physical and mental health of workers, but also causes interference to the surrounding environment. So what method can be used to solve it?
First of all, you must know where this kind of dust flies out of the wood crusher. It usually flies out from the feeding outlet. Because the waste wood enters the inside of the wood crusher and is processed and then loaded, some of the dust will mix with the crushed raw materials. It goes out together and floats into the air, causing smoke pollution problems. In this case, we use a bag dust collector to solve the problem. The bag dust collector collects crushed raw materials, then collects a part of the dust, and discharges the crushed raw materials. This can It is an excellent way to prevent smoke pollution. However, there is also a disadvantage of using bag dust collector, which is that you need to clean it frequently in the final stage. Especially when the more dust adheres to the surface of the bag dust collector, it will not be used effectively, and thus dust removal will not be achieved. Purpose, in this case, we need to remove the bag dust collector. The more dust adheres to the surface, the faster the cleaning, the better.
In addition to dust flying out from the feeding outlet, dust may also fly out from the casing. Most of the root causes of such things are that the machine has been running for too long, causing a gap in the casing. Naturally, it may also be that the quality of the equipment itself is not up to standard. , there is a small gap. During reprocessing, dust will use this gap to fly out, thus causing smoke pollution problems. In the above situation, we need to use welding repair method to solve the problem and find out the gap on the shell. Use welding repair to ensure a tight fit and prevent dust from flying out of such gaps during reprocessing.
Only in this way can we focus on solving the problem of smoke and dust pollution from wood crushers. You can choose according to your actual situation. Remember that our country is currently in the green development stage, so we need to pay attention to the corresponding green requirements in production operations.
