tree grinderThere are many raw materials that can be crushed, and there are many raw materials that can be crushed by a crusher. Therefore, jamming or residual materials will occur, and this may also lead to tragic accidents. Therefore, when using a large crusher, you must control it reasonably. , to avoid damage, how to use and clean it correctly? Let’s learn about it together.
1. Cleaning cycle
Usually the company cleans once for every type of product produced, but we think it should be cleaned once a month as much as possible. During the cleaning process, the equipment can be disassembled for careful cleaning. This can extend the service life of the crusher.
2. Cleaning method
1. To clean the internal structure of the tree crusher, you can use a hair dryer to blow hard, and you can use special tools to clean it manually. However, remember not to use a lot of water for cleaning, because the crusher has just stopped rotating and has a corresponding amount of heat. If Clean with clean water. Over time, the internal structure of the pulverizer will rust, reducing the service life of the pulverizer product.
2. To clean the tree crusher, you need to control the raw materials. Based on our experience over the years, we at Jiuzhou Shangyang have found that when crusher customers often have problems with material jamming, the purity of the raw materials on site is not high and the situation is chaotic.
3. During the feeding and crushing process, the raw materials may be mixed with some special materials, such as metal, iron wire, stone, etc. Not only are these raw materials easily stuck on the inner wall of the crusher, but they will also continue to cause damage to the crusher after long-term crushing. The blades of the machine may cause damage. Therefore, it is important to pay attention to the purity of the raw materials, which is also the key to conveniently cleaning the crusher product.
4. Idling the crusher is also a good way to clean the tree crusher product. After the crushing task is completed on the same day, you can let the crusher idle for a few turns, which is helpful for cleaning the inner wall of the crusher, because some raw materials are likely to remain in the crusher tube. Letting the crusher idle on the road or on the screen can perform a simple cleaning effect on the crusher screen and its pipelines.
