In many cases, fault analysis can also be used to determine the failure of the biomass grinder. Different faults have different characteristics. The heat generated during the use of the biomass grinder must be carefully checked.
When this kind of problem occurs, there will be friction sound and obvious shaking during the operation of the biomass crusher. At this time, the operator should turn off the equipment and disassemble the bearings. Repair the friction part, and then as needed Reinstall the rolling bearings of the biomass grinder equipment.
During the operation process of the biomass crusher, please ensure that no other impurities that cannot be crushed are crushed. The hammer head of the equipment should be prevented from forming sparks after being collided with these impurities. On the other hand, it should be avoided that these materials that cannot be crushed are crushed. After crushing in the cavity, the sieve plate is damaged, which affects the overall crushing effect. There is sufficient air volume to ensure that the air volume has a relatively high sieve hole perforation rate, which can increase the rate at which the crushed materials use the sieve holes to discharge the sieve plate, and there is sufficient The air volume can separate the crushed materials and impurities. The purpose of our improved feeding equipment is to allow the materials to be crushed into the biomass crusher to keep the feeding as uniform as possible and maintain the relative stability between the equipment's production volume and production current. .And it is required to adjust the feed flow accordingly to ensure that the working current of the biomass crusher is always stable. From the working content of the biomass crusher equipment, the mechanism of the feeding equipment directly affects the crushing effect of the equipment.
Faced with this kind of situation, first of all, we must be able to correctly determine whether this is a normal condition or caused by a fault. This is very critical. This is related to our next operation of the biomass grinder.
What issues need to be paid attention to when adjusting the biomass crusher? Let me introduce it to you below.
1. Before using the new machine, first open the top cover and check the distance between the moving and fixed blades. The gap between the moving blade and the fixed blade is preferably 0.2mm-0.3mm. (There is an adjustment bolt at the moving knife).
2. Check whether the bolts fixing the bottom of the screen are loose, then lower the top cover and tighten the bolts.
3. The outer sections of the main wheel and the power wheel must be on the same plane. After the belt is installed, the tightness must be adjusted appropriately and not too loose or too tight.
4. Before starting, you can turn the belt pulley over by hand. There should be no friction or impact during the turning. It can be started only after it is normal. Check the working direction and you can produce normally. Therefore, it can be seen that the adjustment before the equipment is very critical. Application production Customers of material crushers must not be careless.