Common application considerations:
1. The motor used in Bandite wood crusher must have a safe and reliable grounding device to prevent accidents.
2. The wood crusher should be operated under no load, and then run idling for 2-3 minutes. Observe that there are no abnormalities in the equipment before loading the material. Feed the material as evenly as possible when loading, and ensure that the motor is working under the rated load and can be used at any time. Observe that the bearing temperature should not be too high. If there is an over-temperature condition, the machine should be shut down and inspected immediately to prevent damage to the bearings, spindle bearings, etc.
3. After the feeding is completed, let the crusher continue to operate for 1-2 minutes. After all the materials in the standby period are crushed and discharged, shut down.
4. When cleaning the blockage in the crusher, adjusting and replacing the hammer blades, screen blades and transmission belts, disconnect the power supply and wait until the equipment stops operating to ensure safety.
5. Regularly maintain the hammer to check whether the flat teeth are cracked or worn. If you replace the hammer or flat teeth, try to choose regular spare parts from the original manufacturer. There are many counterfeit hammers and flat teeth on the market at this stage. , customers should purchase with caution to prevent equipment damage caused by the use of counterfeit spare parts.
6. The super large wood crusher should select the power (electric motor or diesel engine) according to the specified supporting power, and the speed ratio of the supporting power should be selected strictly according to the rated speed ratio of the main shaft bearing of various specifications of wood crushers. The speed ratio of the main shaft bearing should not be increased. Speed ratio. Overspeeding of the pulverizer usually creates very large safety hazards.
7. In addition, customers need to pay attention to the fact that in order to avoid dust explosions, the crushing work site should be wide, ventilated, and equipped with safe and reliable fire prevention facilities.
Reasons and solutions for vibration of large wood crusher body:
1. The weight difference between the two sets of hammer blades corresponding to the Bandite wood crusher exceeds 5 grams. The way to eliminate this is to adjust the weight of the hammer blades so that the weight difference between the two corresponding sets is less than 5 grams.
2. The main shaft bearing of the wood crusher is bent and deformed. The solution is to straighten or replace it.
3. The fixing bolts at the bottom corners of the wood crusher are not fastened tightly or become loose during operation. The solution is to tighten them.
4. The bearing clearance of the wood crusher exceeds the limit or is damaged. Generally, new bearings can be used to solve the problem.
5. The rotor of the wood crusher is checked and balanced through a dynamic balancing machine.
6. The weight of other parts on the rotor of the large wood crusher is unbalanced. At this time, it is necessary to carefully check and adjust the balance separately.