The adjustment of the pressure torsion spring tension of the Bandit wood crusher is achieved by adjusting the relative position of the adjustment plate and the round hole on the support frame. From the rotation of the adjustment plate until the spring just touches the pressure plate, the front cotton head continues to rotate. Adjust to 3 holes on the adjusting plate, adjust the rear cotton head to 4 holes, align with the fixed holes on the support frame, and insert the flange screws. When adjusting the wood crusher, you must first adjust the pressure plate on the rear cotton head. , tighten the pressure plate on the front picking head only if necessary.
By adjusting the length of the booms on both sides of the girder of the cotton picking head, the front roller barrel is 19mm lower than the rear roller barrel when the wood crusher is working. This makes the picking spindle contact more cotton and allows the residue to escape from the bottom of the cotton picking head. The end flows out, and the inclination adjustment should be carried out inside the cotton row.
Wood crushers have both blades and hammers; usually people who don’t understand the equipment won’t be able to adjust the blades at all, and the screen is easy to install backwards, which can easily cause damage to the equipment, and instead say that the quality of the equipment is substandard.
Blades are easy-to-wear components. They need to be replaced after a period of use. Replacing blades can ensure quality and improve productivity. Failure to replace worn blades early will cause uneven wood crushing fineness, reduce production volume and crushing quality. How to replace wood crusher blades As for tips, when replacing the blade, shut down the machine and cut off the power. When the blade is not sharp, it should be sharpened as soon as possible. If the blade is not very worn, it can be sharpened with a whetstone. When the wear is relatively large, the flat blade can be ground with a flat grinding wheel, and then finely ground with a whetstone. sharp.
The blade angle should be lower than 38 degrees, and coolant should be added when grinding with a grinding wheel to avoid edge annealing. If the blade is seriously worn, a new blade needs to be replaced. Install and adjust the blade, adjust the edge height, and expose the flat blade edge. Outside the plate, after the vertical height is adjusted, the knife pressing bolt should be tightened after adjustment to prevent the blade from moving and damaging the equipment. When adjusting the fixed knife, the gap between the fixed knife and the movable knife should be adjusted to 1 to 2 mm.
In fact, for equipment such as the Bandit Wood Shredder, the blade is a movable knife and is fixed with screws. When used normally, it feels that the equipment is no longer as productive as before, then the blade may be dull, and you only need to replace the blade. Take it off or remove it, and then use a sharpener or sharpen it on sand and gravel; repeat this cycle until the edge is worn out (the blade can be used for 4 months).
After replacing the blade, check whether the bolts in each part are firm. If they are loose, tighten them. Rotate the belt pulley by hand. There should be no friction between the machine parts and the casing to ensure safety. After starting up, the machine should run normally. Material can only be fed when the speed is at a high speed. It cannot be started with the material. When feeding, the hand cannot go deep into the feeding port to avoid being injured. If the machine makes abnormal noise during operation, it should be shut down and checked for faults to prevent damage to the machine. The operator should not be loading materials. The mouth should be in the middle of the mouth and should be loaded sideways to prevent accidents.
