Do not use gasoline oil to replace the engine oil of the tree grinder. Otherwise, the oil will be easily oxidized and deteriorated, and it will also cause damage to the non-corrosive bearing sleeves. The lubricating grease of the Bendite tree grinder cannot be used with oil. or diesel blending. Adding oil or diesel to the grease will easily drain the grease and reduce the use of the grease. Do not use engine oil instead of brake oil. Replacing the brake oil with oil will cause the rubber components of the brake system to swell, causing damage to the brake system. The hydraulic system fails. Hydraulic oil cannot be used to replace the engine oil. The hydraulic oil of the tree crusher acts as oil and produces a paint film in the combustion chamber, which cannot be removed and will increase wear after replacement.
In addition, when changing the oil of the tree crusher, try to use it as much as possible to ensure economical use of the oil. In the case of technical conditions such as oil detection and identification, the oil should be changed as much as possible to reduce oil consumption and costs. In addition, , in order to extend the service life of the engine oil, the old oil should be drained and the lubrication system should be cleaned. The crankcase ventilation should be kept working. When adding new oil, be careful not to allow impurities and moisture to mix in. Replace the oil and replace the filter device.
Before the Bandite tree crusher is operated, all components of the tree crusher must be inspected and adjusted in accordance with regulations, and can be operated after meeting the requirements. The moving and fixed blades of the tree crusher should continue to keep the cutting edges sharp. Otherwise , it should be removed in time for sharpening; during the installation process, the bearings on 2 sides of the main shaft and the bearings on 2 sides of the feed roller were filled with grease and straw packaging. One month after applying the equipment, the tree crusher The above-mentioned bearings need to be removed. After cleaning, re-apply grease, install and use, and lubricate the tree crusher for one month after each operation. Secondly, other rotating components should be lubricated with oil frequently during use;
It is also necessary to frequently check whether the parts of the tree crusher are seriously worn and loose, especially the working components and rotating components. If damage, serious wear and looseness are found, the tree crusher should be replaced in time, repaired and tightened. It is strong to prevent Cause safety accidents; when the tree grinder is stopped, the dust and stains on the surface should be cleaned up. If the tree grinder is parked in the open air, please use a waterproof tarpaulin to cover it to prevent the equipment from rusting.
