In most cases, faults can also be used to determinebiomass crusherFault diagnosis. Different types of faults have different types of characteristics. Careful inspection must be carried out regarding the heat generated during the use of the biomass grinder.
When such problems occur, friction sounds will be produced during the operation of the biomass grinder, and there will be obvious shaking. At this time, the operator should shut down the equipment and disassemble the roller bearings. Modify the friction part, and then follow the instructions It is necessary to reinstall the roller bearings of the biomass grinder equipment.
Faced with this situation, first of all, we must be able to accurately understand that this is also a normal situation and is caused by a malfunction. This is very critical. This is related to the next operation of the biomass grinder.
What should we pay attention to when adjusting the biomass crusher? Next, I will recommend it to you.
1. Before using the new machine, first open the machine cover to check the distance between the moving blade and the fixed blade. The gap between the moving blade and the fixed blade is preferably 0.2mm-0.3mm. (There is an adjustment bolt at the moving knife).
2. Check whether the bolts fixing the bottom of the screen are loose, then put down the machine cover and tighten the bolts.
3. The outer sections of the main wheel and the power wheel must be on the same plane. After the belt is installed, the tightness adjustment must be appropriate and should not be too loose or too tight.
4. Before operation, the belt pulley can be turned over by hand. There should be no friction or impact during the turning. It can be operated only after it is normal. If the direction is checked daily, normal production can be achieved. Therefore, it can be seen that the adjustment before the equipment is very critical. Users of biomass crushers must not be careless.
