The tree grinder is a relatively common type of industrial equipment for crushing branches. The tree grinder is mainly used to crush raw materials. It has a very good effect on the reuse of branches and wood waste, and it also has an environmentally friendly effect on our living environment. However, tree crushers also need maintenance and upkeep in daily work. So how should the walking system and lubrication system of the tree crusher be maintained?
Maintenance and maintenance of walking system
The walking system of tree crushers is usually relatively simple. Most of them are trailer-type, a small part are human-pulled, and a small part are fixed. For trailer-type equipment, the following maintenance should be performed:
1. Check the tightening torque of the wheel hub mounting bolts after the trailer has been driven for 8 hours.
2. Check the tire pressure after the trailer has been driven for 8 hours.
3. Check the tire bearings every 12 months and add grease.
Very Instructions for Equipment Maintenance
1. Pay attention to the daily inspection and maintenance of standard parts of the spindle, spherical bearings, and seated bearings. If there is any looseness, fix it in time, which can prevent equipment failure and accidents.
2. During the work process, the equipment should be supported stably and should not be shaken.
3. The length of the inner 6-corner bolts for installing the blade must comply with regulations. If it is too short, it will easily loosen, and if it is too long, interference will occur. Screws with damaged inner 6-corner corners cannot be reused to prevent difficulty in disassembly and assembly.
4. If there is any abnormality in the equipment, such as violent vibrations, strange noises, etc., it should be shut down immediately for inspection, otherwise serious equipment damage or injuries may occur.
Maintenance and maintenance of lubrication system
The lubrication system of the tree crusher mainly adds lubricating grease to the bearing parts. The customer uses the grease fitting to add lubricating grease to the equipment after every 30 hours of operation.