When the large wood crusher is operating, it is necessary to use a motor as a power protection device. The power is transmitted to the main shaft bearing, and the transmission gear on the other side of the main shaft bearing transmits the changed power to the pressure grass through the gearbox, cross shaft, etc. The raw materials to be processed enter the lower-pressure grass in the upper layer, compress it and send it into the knife cutting tissue at high speed. After cutting with a large wood crusher, it is thrown out of the grass outlet of the equipment.
The other is towed, that is, towed on a tractor powered by a diesel engine. Always check whether the standard parts are loose and tightened. Enhance the protection of the bearing seat, coupling and transmission. Fill or replace lubricating oil on time And grease. The price of a large wood crusher with adjustable cutting angle should be adjusted according to the thickness of the crop stem to ensure that the large wood crusher. Equipment price is normal. When you find that the edge of the blade is dull, please use a whetstone to sharpen it. blade. After each shift, the dust on the equipment should be cleaned in time. After each season, the debris in the equipment should be cleaned, and anti-rust agent should be applied to the working components and placed in a ventilated and dry place. Angry place.
The working area of the large wood crusher should be wide and equipped with fire-fighting equipment. The motor serves as an auxiliary power supply. The power is transmitted to the main shaft bearing, and the transmission gear on the other side of the main shaft bearing transmits the changed power to the pressure grass through a gearbox, cross shaft, etc. When the raw materials to be processed enter the upper layer of grass with lower pressure, they must be held and fed into the knife to cut the tissue at a suitable speed. After the large wood crusher is chopped and thrown out of the equipment through the grass outlet, it is found that the edge of the blade becomes The movable blade is dull and has been sharpened by the whetstone. Before stopping work, you should first place the transmission handle in the 0 position, let the equipment idle for about 2 minutes, wait for the dust and weeds on the equipment to be blown away, and then stop.